KOREAFITTER

Pipe Saddle Template Generator

Pick the header and branch pipe size, download a full-size PDF, wrap it around the branch pipe and cut along the line. Free, no sign-up.

Units

Print at 100% / “Actual size”. Check the 100 mm bar on every page before cutting.

–Saddle depth
–Wrap length (branch OD × π)
–Pages to print

Dashed boxes = printed pages. Keep the paper below the cut line; cut away the pipe above it.

Need more than a 90° saddle?

Elbow trunnions, beam dummies, elbow miter cuts and dummy-leg cut lengths from center height — in the free Android app, made by a working pipefitter.

Get it on Google Play →

Pipe ISO & cut-list calculator

Sketch the ISO, get CL/CUT cut lengths, 2D offsets, parallel runs and elbow miter cuts — export PDF/DXF. Free Android app.

Get it on Google Play →

Saddle templates by pipe size

Ready-made layout tables for common header × branch combinations. Each page links to the full-size PDF.

How to use the printed template

  1. Print the PDF at 100% (Actual size). Measure the 100 mm bar — if it is off, your printer scaled the page.
  2. If the template spans several pages, trim along the dashed lines and tape the pages edge to edge in page-code order (A1, A2…).
  3. Cut along the outer edge of the template and the CUT LINE.
  4. Wrap it around the branch pipe with the straight bottom edge square to the pipe. Line up the seam with the overlap tab.
  5. Point the SIDE (horn) marks to the sides of the header and the RUN AXIS marks along the header. Trace the line with a soapstone or paint marker, then cut and grind to fit.

FAQ

Which diameter does the template use?

Outside diameter (OD) of both pipes, per ASME B36.10. The cut follows the outer surface, which is what you mark on site. For a full-penetration bevel, grind the inside afterwards.

Can the branch be bigger than the header?

No. For a 90° saddle the branch OD must be equal to or smaller than the header OD.

Is this the same as a dummy leg / pipe support cut?

Yes — a straight dummy leg welded under a horizontal pipe uses exactly this saddle cut. The app also gives the long and short leg lengths from the pipe center height.